Setip Command - MA lighting dot2 User Manual

8.56. SetIP Command

This page describes the syntax and how to use the
To use the SetIP command, type
Description
Important:
Before using the SetIP command, save the show file. To save the show file, press
Backup .This is necessary because after the SetIP command, the console needs a reboot to apply the
new IP address.
Important:
The Art-Net IP address has to be an address with 2.x.x.x. or 10.x.x.x. .
With the SetIP command, you can:
Change the Art-Net IP address
Change the sACN IP address
See the available Ethernet interfaces along with their IP address in the
After an IP address change, a reboot is necessary.
Syntax
1. Change the Art-Net IP address.
SetIP eth0:1 2.2.3.5
2. Change the sACN IP address.
SetIP eth0 192.168.0.5
3. Displays the available Ethernet interfaces along with their IP address in the
SetIP
Example
Let´s assume, it is necessary in your network to change the Art-Net IP address.
1. To save the show file, press
2. Open the command line window
SetIP eth0:1 2.2.3.5
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
SetIP
command.
SetIP
in the command line.
Backup Backup .
to use the virtual keyboard and type:
Backup
command line window.
command line window.
450