Fade Command - MA lighting dot2 User Manual

Example 3
Let´s assume, you will delete cue 1 from a executor button 1.
There are three different ways to do this.
a) Press Delete 1 (= Cue 1)
b) Press Delete 1 (= Cue 1) and tap on the executor 1 in the
c) Press Delete 1 (= Cue 1) and press the respective executor button
If a cue list is stored on executor 1, the console ask to
Example 4
Let´s assume, you will set intensity of executor 1 at 50 %.
Important:
The physical fader doesn´t move.
To grab the fader again, you have to move the fader once to the actual value.
The fader is working.
Hint:
To apply values to the main executor, type only
number.
Press Exec 1 At 50 Please
The executor has now 50 %. This is the same as you would move the fader up to 50 %.
Example 5
Let´s assume, you will trigger executor 1 by a
Press the small Go + (=Go )
Executor 1 is triggered by a Go command. This is the same as your executor button is assigned with a Go command.

8.21. Fade Command

This page describes the syntax and how to use the fade command.
To go to the fade command it is necessary to press another function key before, e.g.
Description
With the fade command, you indicate fade times
to go to a cue with a fade time
for a new created cue with fade time
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Exec 1 Please .
choose the delete
.
Go command.
Exec 1 Please .
executor bar view.
on the console.
method.
Exec in the command line without an executor
Store Time (=Fade).
404