MA lighting dot2 User Manual page 344

If you start cue 1, fixture 1 gets at full and fixture 2 will preset its position. If you start cue 2, only the dimmer of
fixture 2 gets at full.
Figure 2: Values of cue 1 with active MIB late
Hint:
If you want to deactivate MIB late only for several fixtures on the executor, store these fixtures in the
previous cue with a dimmer values of 1.
Autostop
Information:
Use autostop only for fader executors.
To activate autostop for the executor, tap at the prohibition sign.
If autostop is on, the executor turns off when a fader position of 0 is reached.
If autostop is off, the executor stays on when a fader position of 0 is reached.
Use Master Speed
To deactivate master speed for an executor, tap at the tick mark.
If an executor uses master speed, the master speed fader controls the speed of effects in cues and chasers for this
executor.
If an executor does not use master speed, the master speed fader does not control this executor. Effects use the
stored effect speed.
For more information, refer to
Use Master Rate
To deactivate master rate for an executor, tap at the tick mark.
If an executor uses the master rate, the master rate controls the speed of the cue fade and cue delay timings.
If an executor does not use the master rate, the master rate does not control this executor.
For more information, refer to
Swop Protect
To turn swop protect on, tap at the tick mark.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Magic Speed View.
Magic Speed View.
344