MA lighting dot2 User Manual page 191

d o t 2 U s e r Ma n u a l
Tap to leave the current view.
OK
: Located on the right side of a title bar.
Tap to confirm your changes.
Frame:
Located on the right side of the Wing & Nodes Diagnosis Window.
Tap to identify the selected device in the network.
Effect Mode Title Bar
If an effect is running on the selected fixtures and the preset type of the running effect is selected in the preset type
bar, the preset type view changes into an effect mode and gets a purple title bar.
Figure 2: Effect Mode Title Bar
Effect Loop:
Located in the preset type views title bar.
Tap to open the corresponding effect view.
Normal Value:
Displays the current effect between the selected low value and high value.
Tap to overwrite the running effect with a normal value.
Low Value:
Tap to change the lowest value of the selected effect.
High Value:
Tap to change the highest value of the selected effect.
Preview Title Bar
If the preview mode is on, the fixtures view changes into a preview mode and gets an red title bar.
Figure 3: Preview Title Bar
To leave the preview mode, press Off Prvw .
191
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com