MA lighting dot2 User Manual page 250

The executor time master overrides cue fade, on/off times, and sets the cue delay to zero.
The program time master controls the fade times of all program values, between 0 and 10 seconds.
This affects both, the adding of new values into the programmer, and the removing of values from the programmer
with the Clear key.
To leave the Empty Executor Window, tap Esc in the title bar or press
Example Store Executor
Let´s assume, you will store the active programmer values as a cue on an executor 1.
Figure 2: Executor with one cue
1. Tap on the empty executor 1 in the
2. Tap Store Executor .
The active program values are stored on executor 1 as cue 1.
Example Group Executor
Let´s assume, you will store the selected left side dimmer fixtures as a group master on the empty executor 6.
Figure 3: Group Master
1. Select all left side dimmer fixtures in the
2. Tap on the empty executor 6 in the
3. Tap Store Group Executor .
The executor 6 is a group master.
Example Rate Executor
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
executor bar window. The empty executor window opens.
fixtures view.
executor bar window. The empty executor window opens.
Esc on the console.
250