Copy Command - MA lighting dot2 User Manual

Syntax
Clone fixture 1 at fixture 2.
Clone Fixture 1 At 2
Example 1
Let´s assume, you did programming for 2 fixtures (ID 1 and 2) and then you realize you will add three more fixtures at
this spot doing the same as the other one.
Figure 1: Fixture 1 and 2 are programmed ready
Press + Copy (= Clone)
The console will ask you to
Fixtures 1 and 2 are cloned at fixture 3 thru 5. All fixtures doing exactly the same.
Figure 2: Fixture 1 and 2 are cloned at fixture 3 thru 5
Example 2
Let´s assume, you will clone the fixtures (ID 31 and 32) only on executor 1, because you need one more fixtures for
the actors light.
The If command limited the Clone command, that the cloning work only for the executor 1.
Press + Copy (= Clone)
Please .
The console will ask you to
Fixtures 31 and 32 are cloned at fixture 33 thru 35, only on executor 1.

8.11. Copy Command

This page describes the syntax and how to use the copy command.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Fixture 1 + 2 At 3 Thru 5 Please
choose the clone method.
Fixture 31 + 32 At 33 Thru 35 If
choose the clone method.
.
and the respective executor button
388