MA lighting dot2 User Manual page 98

d o t 2 U s e r Ma n u a l
The following is a short description of the different values you can adjust.
Low / High value
The effects are mowing between two values. Called High and Low.
Speed
How fast your effect runs is defined by a speed parameter. This is measured in Beats Per Minute (BPM). The speed is
also affected by the Master Speed special master - if it's active and turned on for the executor where you have
stored the effect.
Phase
Phase is what could also be called distribution. This is where we can spread out the fixtures over the effect cycle.
If all your fixture have the same number in phase then they will all be at the same place in the cycle.
In this image there's 6 fixtures all at the green point in the sinus form:
If we spread them out evenly then they could look like this:
Each green point is a fixture. This is using one of the predefined phases called "0..360".
You can create nice looks and grouping by pressing the Align key and then keep turning the encoder in one
direction. When you have values on the Phase with great separation you can create interesting looks.
Align <>
The function can be used to create "mirrored" effects.
Width
98
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com