Select Command - MA lighting dot2 User Manual

To apply and leave the window,tap Ok .
To apply and get a detailed report, tap Ok Create Report .
Fixture 1 is replaced with fixture 2 if it was used on executor 1.
Example 3
Let´s assume, you will replace group 1 with group 2.
Important:
Replace group will not replace the group in the groups view.
It will replace the fixtures using in the group in the show file. This is the same as replace fixture with
fixture.
There are two ways to do this:
a) Press + Move (=Replace)
b) Open the groups view. Press
Please .
The console gives you an overview about how many objects will change and asks, to confirm the replace operation.
To apply and leave the window,tap Ok .
To apply and get a detailed report, tap Ok Create Report .
All fixtures stored in group 1 are replaced with the fixtures stored in group 2.
Example 4
Let´s assume, you will delete fixture 1 from all places where it is stored in (groups, presets and executors).
Press + Move (=Replace)
The console gives you an overview about how many objects will change and asks, to confirm the replace operation.
To apply and leave the window,tap Ok .
To apply and get a detailed report, tap Ok Create Report .
Fixture 1 is deleted from all places in the show file, where it was stored in.

8.54. Select Command

This page describes the syntax and how to use the select command.
To go to the select command, press
Description
With the select command, you select fixtures
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Group 1 Move (=With)
+ Move (=Replace), tap at Group 1 , press
Fixture 1 Move (=With)
Select on the console.
Group 2 Please .
Move
Please .
(=With), tap at Group 2
447