MA lighting dot2 User Manual page 41

'All Delay'
is grayed out and can't be used.
'[Preset type] Fade'
- Each of the possible preset types have their own fade column. This is used to set a fade
time for that specific preset type. The unavailable preset types are grayed out and cannot be changed. More
about Preset types later. If the background of a cell is dark and the number is black, then it's not an active values
and will not have any influence in how the cue is played back. White values are active and will influence the cue
playback.
'[Preset type] Delay'
- Each of the possible preset types have their own delay column. This is used to set a delay
time for that specific preset type. The unavailable preset types are grayed out and cannot be changed. More
about Preset types later. If the background of a cell is dark and the number is black, then it's not an active values
and will not have any influence in how the cue is played back. White values are active and will influence the cue
playback.
'Cmd'
is short for command. This is used when we need to trigger something else with the cue - we are going to
explore that later.
'Snap Percent'
is a special function used with complex fixtures that have things like gobo wheels. Some things
are set to "snap" from the old position to the new, instead of fading from one to the other. Snap Percent is used
to set the point in the cue fade time when the gobo wheel should change position. 0% is when the fade begins.
100% is when all the fade times are done.
When we add more advanced fixtures to our show then the grayed out delay and fade column for each of the
different preset types will be available.
Most of the elements can be changed using the
keep it pressed while you rotate. When you have a blue background on the name you can release the encoder and
then just to press it shortly - if you are using the dot2 onPC, then you can't do this, instead you can use the mouse
and right click the cell.
This gives us the Edit Name pop-up. Change the name to
just want to change the width of the columns you can do this by pressing on the black line between the column
headlines and then while pressing, move your finger to change the width.
When you are done it should look something like this:
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Edit key. We can also use the rightmost encoder. Press it and
Behind Curtain
. If you can't see the entire name or you
41