Storelook Command - MA lighting dot2 User Manual

Example 5
Let´s assume you will store a master speed fader on executor 3.
There are three different ways to do this.
a) Press Store Speed (= Rate)
b) Press Store Speed (= Rate) and tap on the executor 3 in the
c) Press Store Speed (= Rate) press the respective executor button e.g.
The console asks, to select the speed master type. Tap Master Speed .
A master speed fader is stored on executor 3.

8.60. StoreLook Command

This page describes the syntax and how to use the StoreLook command.
To go to the StoreLook command, press and hold
Description
With the StoreLook command, you can store your actual look as a cue on an executor.
The StoreLook command stores all dimmer values from all fixtures in the show.
If the dimmer value is bigger than 0 it stores additional all further attributes.
If the dimmer value is 0, it stores only the dimmer value because there is no further actual output of the fixture.
A cue stored with the StoreLook command is automatically set to protected. Previous tracked values does not affect
a cue stored with StoreLook. For more information about protected, refer to
For more information about tracking, refer to
Syntax
Store the actual look from all fixtures in the show.
StoreLook
Example
Let´s assume you will store the actual look from all fixtures in the show as a cue on executor 1.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Exec 3 Please .
and Store
What is Tracking?
executor bar view.
on the console.
on the console.
Cues View or How to work with cues.
456