Remove Command - MA lighting dot2 User Manual

d o t 2 U s e r Ma n u a l

8.52. Remove Command

This page describes the syntax and how to use the remove command.
To go to the remove command, press and hold and Delete on the console.
Description
With the remove command, you remove stored values from a cue.
Remove works always along with a merge in a existing cue.
Syntax
Remove dimmer values.
Remove PresetType Dimmer
Example
Let´s assume, you will remove the dimmer value of fixture 4 in cue 2.
1. Select the fixture type in the fixtures view.
2. Press + Delete (= Remove) and tap on Dimmer in the preset type bar.
The remove value is in the fixtures sheet view visible.
Figure 1: Remove values in the fixture sheet
3. Press Store 2 (= Cue 2) Please .
The dimmer values of fixture 4 in cue 2 are removed.
8.53. Replace Command
This page describes the syntax and how to use the replace command.
To go to the replace command, press and hold and Move on the console.
Replace is in the command line.
Replace With
If you press Move after a is in the command line, the command will be .
Description
445
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com