Group Command - MA lighting dot2 User Manual

Control console

Hide thumbs Also See for dot2:

Table of Contents

8.30. Group Command

This page describes the syntax and how to use the group command.

To go to the group command, press

With the group command you select a group from the

All fixtures stored in the group are selected in the

The order of the selected fixtures is the same order as you select the fixtures and stored them in a group.

Select a group in the groups pool along with the stored fixtures in it.

Let´s assume, you will select all stored fixtures in group 1.

There a two ways to do this.

a) Tap at group 1 in the

Group 1 Please

All fixtures stored in group 1 are selected in the fixtures view.