MA lighting dot2 User Manual page 79

dot2 Wings
When you have made all the physical connections, you need to connect the equipment to the console. Press
Setup and then dot2 Wings .
The window could look like this:
Figure 1: Wing setup.
Here you can choose a free wing slot (of the right kind) to connect a wing.
When you select a free slot then you get a list of available wings in your network. When you select a wing in the list,
then it begins to flash. This identifies what wing you have selected. Select the device you want and press
Assign selected .
That's it for wings.
dot2 console, dot2 onPC, dot2 Node4 (1K) and dot2 3D visualizers
The story is a little bit different for the rest of the dot2 devices.
To connect consoles, onPC, nodes and 3D visualizers we need to have a session running. Press
Sessions . If your console is already part of a session then the top right button will say Stop/leave session and the
text next to it tells you what session you are a part of. If you don't have a running session then the button says
Start new or join an existing session . There can be four different sessions running in a network. To connect your
consoles, onPC, nodes and 3D, then they need to be in the same network and they need to join the same session
number. When you press the Start new or join an existing session button then you get four buttons - one for each
session. If a session number is already used then the button will say Join session . If there's no session running you
have the option to tap New Session and begin you own new session.
You can add Consoles, onPCs, 3D and DMX Nodes into your session by having a session running and then in the
Sessions view under "Connected Devices" you can tap the Add button. This will give you a list of all available
devices in your network.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Setup and then
79