Network Setup Window - MA lighting dot2 User Manual

d o t 2 U s e r Ma n u a l
The green tick displays, that this network protocol is enabled.
The red prohibition sign displays, that this network protocol is disabled.
To enable or disable a network protocol, tap at the network protocol type.
Below the network protocol is the IP address displayed from which the network protocol is sent.
The Art-Net IP address is visible after Art-Net is enabled and a session is active.
To change the IP address, use the SetIP command.
The following columns are available:
Active:
Displays if Art-Net or sACN is on or off for the respective universe.
To turn Art-Net or sACN on or off for the respective universe, tap and hold the cell or press the Scroll Active encoder.
Mode:
Displays the supported mode of the network protocol.
Art-Net = Output Broadcast (Art-Net 1)
sACN = Output Multicast
dot2 Universe:
Displays the dot2 universes from 1 to 8.
Art-Net universe / sACN universe:
Displays the Ethernet universe.
Art-Net = 0:0 - 0:7
sACN = 1 - 8
Encoder Bar Functions
Encoder Bar - Network Protocols Configuration Window
Network Protocol:
To select a network protocol, turn the encoder left or right.
To enable or disable a network protocol, press the encoder. The current status is displayed in brackets.
Scroll Active:
To scroll in the active column, turn the encoder left or right.
To select on or off in the active column, press the encoder.
Select Active:
To select multiple cell, press and turn the encoder left or right.
A blue frame around the cells displays the selected cell.

7.45. Network Setup Window

295
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com