Default Command - MA lighting dot2 User Manual

Cue 2 is copied at cue 9.
Related Links
What is Cues
How to work with Cues
Cue Key

8.13. Default Command

This page describes the syntax and how to use the default command.
To go to the default command press and hold
Default is in the command
Default
Description
With the default command you can set all attributes back to their default values
of fixtures
of a preset type
Syntax
1. Set all attributes of a fixture back to their default values.
Fixture 1 Default
2. Set the attributes of a preset type back to their default values for the selected fixtures in the
Default PresetType "POSITION"
Example 1
Let´s assume, you will set all attributes of fixture 1 back to their default values.
There are three ways to do this:
a) Press + . (=Default) and tap on fixture 1 in the fixtures view.
b) Press Fixture 1 +
c) Select fixture 1 in the fixtures view, press
Figure 1: Fixture 1 set to default
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
and
line.
. (=Default).
+ .
. on the console.
(=Default) Please .
fixtures view.
392