MA lighting dot2 User Manual page 179

Pressing the Time key opens the
Using this window you can set the different times used when storing new cues.
If you are storing a cue and you have pressed the
different default timing than the factory defaults.
Also when you are storing cues, you can temporary store a different time than your defaults using the
When using Time with Store you get the
Example
You want to store cue 2 with a fade time of 3 seconds. You press:
Store Cue 2 Time 3 Please
Notice that the command line is actually changing the time command into fade:
Store Cue 2 Fade 3
If you continue to press the Time key during the store operation, you can get to all the different possible timings in a
cue (except the preset type timings).
Store Cue 1 Time 2 Time 3 Time 4 Time 5 Time 6 Time 7
Gives you this in the command line:
Store Cue 1 Fade 2 OutFade 3 Delay 4 OutDelay 5 SnapPercent 6 CmdDelay 7
Special Masters
You can use the Time key to create two different special masters.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Time defaults window.
Store key, then the
Fade Command.
Time key will flash when you have set a
Time key.
179