MA lighting dot2 User Manual page 120

d o t 2 U s e r Ma n u a l
window. You can set these by pressing the Time key (with an empty command line). It could look like this:
Figure 2: Time defaults window.
If you want to store your cue on a different executor (not the main executor), the you need to press a key associated
with the executor. E.g. you want to store cue number 2 on a specific executor. Then you'll need to press the
following keys: Store Cue 2 and then press one of the keys associated with the executor where you want the
cue.
Auto Unblock
Storing a cue will do an . This means that after you have stored a cue all unchanged values are
Protect
removed. Please use the function (read below) if you want to "block" a cue.
The dot2 is a tracking console. If you don't know what this means please have a look at the What is tracking help
page.
Update a cue
You can always store your current active programmer content into any cue you want.
But if you have an active cue running, then you have the possibility to use the Update key. It's a faster work flow. If
you press Update Please , then you update the active cue on the main executor.
If you press Update followed by a key on one of the other executors, then you update the active cue on that
executor. If there isn't an active cue, then nothing happens.
Normal Cue Only
Update will give you a windows asking how to update. There are two modes called and . Normal
will do a tracking update and Cue only will preserve the values in the following cue.
120
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com