MA lighting dot2 User Manual page 233

If a cue is set to protected, a white line is displayed to see where the tracking stops. For more information, refer to
What is Tracking?
If the assigned fade or delay time is overwritten by the exec time master, it is indicated by an equal sign in front of
the fade or delay time.
Figure 3: Cues View - Overwritten fade time
Chaser
If the executor is set to a chaser, all cue functions and timings which are not active in the chaser mode are shown
gray out. For more information about chasers, refer to
Additional is the chaser bar visible.
Figure 4: Chaser Bar in the Cues View
Forward
(chaser direction mode):
Tap at to select the direction mode of the chaser.
There are four directions modes available
Forward
Backward
Bounce (e.g. starts with cue 1 to 4 and goes back from 4 to 1)
Random
Endless
(chaser run mode):
Tap at to select the run mode of the chaser.
There are three run modes available.
Endless
Shoot-Off
The chaser starts at the selected cue, e.g cue 1, and stops at the end of cue 5. The executor is off after the last
cue.
Shoot-On
The chaser starts at the selected cue, e.g. cue 1, and stops at the end of cue 5. The executor is on after the last
cue.
Play:
Tap to start the chaser.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
What is a Chaser? and How to work with Chasers?.
233