Selection Command - MA lighting dot2 User Manual

c) Press Select Cue 1 Exec 1 Please
All fixtures from cue 1 on executor 1 are selected.
Related Links
Select Key
Fixtures View
Executor Bar View
DMX View

8.55. Selection Command

This page describes the syntax and how to use the Selection command.
To go to the Selection command, press and hold
Description
With the Selection command, you can deselect the current selection of fixtures.
The fixtures are removed from the programmer.
Syntax
Deselect the current selection of fixtures and remove them from the programmer.
Off Selection
Example
Let´s assume, you will deselect the current selection of fixtures and remove them from the programmer.
Figure 1: Selected fixtures in the programmer.
Figure 2: Deselected fixtures in the programmer.
Press Off + Fixture
The current selection of fixtures is deselected.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
.
(= Selection) Please .
and Fixture on the console.
449