MA lighting dot2 User Manual page 400

Control console

Hide thumbs Also See for dot2:

Table of Contents

This page describes the syntax and how to use the Edit command.

To go to the Edit command press

With the Edit command, you can edit

open the cues view of an executor

As long as you are in the edit mode, the

To update the edited values, press

To leave the edit mode, press

1. Open the cues view of an executor.

Edit Executor 1

2. Edit a cue.

Edit Executor 1 Cue 2

3. Edit a preset.

Edit Preset 1

4. Edit a group.

Edit Group 1

Let´s assume, you will open the

There are two ways to do this:

Edit Exec 1 Please

and then the respective executor button

The cues view of executor 1 is visible at screen 1.

Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com

d o t 2 U s e r Ma n u a l

on the console.

key is flashing.

Update Please

of executor 1 on screen 1.