MA lighting dot2 User Manual page 201

d o t 2 U s e r Ma n u a l
To open the beam effects view at screen 1, tap at in the title bar.
If an effect is running on a selected fixture, the beam preset type view change into an effect mode and get a blue
effect mode title bar.
Shutter/Strobe/Iris View
The Sutter/Strobe/Iris View is the first tab of the beam preset type view.
In the shutter/strobe/iris view, you control the the strobe in hertz (Hz), the strobe duration in seconds (s) and the iris in
percent (%).
Strobe
To select the shutter speed in Hz, move the strobe slider up or down.
There are five strobe value buttons right beside the strobe slider (depending on the fixture type).
Open:
Tap to open the shutter.
Close:
Tap to close the shutter.
Strobe:
Tap to use the strobe effect from the fixture (shutter opens and closes).
Pulse:
Tap to use the pulse effect from the fixture.
Random:
Tap to use the random effect from the fixture. The selected fixtures will have strobe along with a derangement.
Strobe Duration
201
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com