MA lighting dot2 User Manual page 49

d o t 2 U s e r Ma n u a l
Figure 2: The encoders with the correct fixture.
Then we can press the OK in the upper right corner.
Now our fixture type is the correct one. Change the quantity to 4 and the fixture ID to 21.
We also need to change the address for the first fixture. We want to patch them from the first address on the second
DMX universe and we want then to have 20 addresses between them (they only use 13 channels).
Press the rightmost encoder.
Select DMX Address
This opens the window. Here you can see what is patched to the 8 available universes.
Again we can use the encoders to change the patch address. The left encoder selects the universe and the
rightmost encoder selects the address. The middle right encoder is called "Patch Offset" - this can be used to
automatically add more channels between fixtures. We need universe 2, address 1 and we want to have 20
channels between each fixtures start address, so we need to set the Patch Offset to 20. When you have that you can
press the OK in the upper right corner, this takes us out of the Select DMX Address window.
Again we can press the OK in the upper right corner (to close the Add New Fixtures window). This takes us to the
Fixture Setup - all is good here, press the Done in the upper right corner and select Apply All Changes .
That was it. Now you can see in the Fixture Symbol View that we have 4 new fixtures:
Figure 3: New Fixtures in the Fixture Symbol View.
We should also add these fixtures to our Fixture Layout View number 1.
Select the fixtures using a fixture view and press Store followed by selection the number 1 Fixture Layout View and
then tap inside the view. You are now presented with a pop-up asking how you want to store. Select Merge .
Now you can arrange the added fixtures in the view.
It could look like this:
49
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com