MA lighting dot2 User Manual page 48

d o t 2 U s e r Ma n u a l
Now we are going to add some more fixtures to our patch.
We got four Chauvet COLORdash Par-Hex 7 wash fixtures. Our new plot looks like this:
Figure 1: New plot with LED wash.
They are mounted on vertical poles on each side of the stage.
We need to go back into the setup and add these four fixtures. Press Setup and select
Patch & Fixture Schedule .
On the right side you'll find a button called Add New Fixtures - That sounds like something we need.
When you press this, you'll get the Add New Fixtures window .
In the type input field we still have the Dimmer selected. We have all the dimmers we need, so we need to get a
new fixture type. Press the button next to this area where it says Select Other... . If this is the first time this is done,
then the console needs to update the fixture library - That might take a few seconds.
dash 7
When it's done (or if you didn't need to wait for it) you can press the green input field and type .
The search will display every possible hit in the fixture library. The easy way to select the right fixture is using the
encoders.
We need the one from Chauvet called ColordashPar HEX 7. This fixture have several possible modes. We need to
select the mode called "13 channel".
Sometimes when you add fixtures they'll only have one mode available. Then the mode will often be called "00".
This is the case for our dimmers - remember they have a 00 at the end.
Ok, back on track. When you've found the Hex 7's, the bottom of your screen should looks like this:
48
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com