MA lighting dot2 User Manual page 316

Additional to the four standard columns, the analog remote control has the Input column.
Input:
Displays the input in from the connected DC Remote Control.
The pin layout is displayed next to the connector on the back of the console.
Pin 1 - 6 = Input 1,3,5,7,9,11
Pin 9 - 14 = Input 2,4,6,8,10,12
There are twelve different inputs available to assign.
This column is read only.
MIDI
For using the MIDI remote, you have to connect a MIDI remote on the MIDI In connector at the back of the console.
Refer to, physical setup and
If you assigned in the column type an executor, and in the column button a fader, the velocity controls the fader
level.
Additional to the four standard columns, the MIDI remote control has the Note column.
Note:
Displays the available MIDI notes from 0 - 127.
DMX
For using the DMX remote, you have to connect a DMX remote at the DMX In connector at the back of the console.
Refer to, physical setup and
To trigger a button or command by DMX in, a DMX value between 128 and 255 is necessary.
The green indicator is only visible if a DMX value above 0 is sent to trigger faders, or above 127 is sent to trigger
buttons or commands.
Additional to the four standard columns, the DMX remote control has the DMX column.
DMX:
Displays the DMX address. This column is read only.
Encoder Bar Functions
Figure 2: Encoder Bar Functions - Remote Inputs Configuration Window
Input Type:
To select a remote input type, turn the encoder left or right.
To enable or disable a remote input type, press the encoder. The current status is displayed in brackets.
Scroll:
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
layout.
layout.
316