MA lighting dot2 User Manual page 297

For consoles and DMX Nodes, the type and the XLR connectors are displayed as well.
Important:
Only the hostname of the Node4s are changeable. All other hostnames are readonly.
To change the hostname of a Node4, tap and hold in a cell of the hostname or press the screen encoder. The
virtual keyboard opens.
The assigned hostname is displayed at the front end display of the Node4.
To change the DMX out universe, tap and hold in a cell of the XLR connector or press the screen encoder. The
Calculator opens.
If only 1 universe in total is patched but different XLR outs are necessary, you can assign the same universe to more
than one XLR out.
Important:
To change the universe, a session is NOT required.
To add a device, tap Add . The
Hint:
To add a device, it is not necessary to select the device column first.
Important:
The connected devices and the hostnames of the Node4´s will be saved in the show file.
To remove a device, select the device in the table, tab Remove . The device is removed from the session.
A device can have four different status:
Light Green:
This is your station.
Dark Green:
This device is session member.
Red Background:
This device is not connect.
The device was connected and is off now.
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
select station... window opens.
297