Zero Command - MA lighting dot2 User Manual

Control console

Hide thumbs Also See for dot2:

Table of Contents

8.68. View Command

This page describes the syntax and how to use the view command.

To go to the view command, press the

With the view command you can view the

View the cues from executor 1.

View Executor 1

Let´s assume you will see the cues of executor 3 on page 1.

Figure 1: Cues View

and then respective executor button

The cues view of the executor is visible on screen 1.

8.69. Zero Command

This page describes the syntax and how to use the zero command.

If you type the Zero command in the console, by double press the

You can also use the command line along with the virtual keyboard and type the word zero in.

To go to the zero command double press the

The command will be directly executed.

With the zero command you can set the intensity to zero:

Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com

d o t 2 U s e r Ma n u a l

key on the console.

key on the console.

key, the command will be directly