MA lighting dot2 User Manual page 452

8.57. SnapPercent Command
This page describes the syntax and how to use the SnapPercent command.
To go to the SnapPercent command, it is necessary to press another function key before, e.g.
times Time .
Description
With the SnapPercent command, you set a snap time.
The snap time is a delay time for non fading parameters, eg. gobo or colorwheel.
Syntax
1. Store a cue with a snap percent of 4 %.
Store Cue 1 SnapPercent 4
2. Assign a snap percent to an existing cue.
Assign Cue 1 SnapPercent 4
Example 1
Let´s assume, you will store a new cue 1 on executor 4 with a snap percent of 2.
There are three ways to do this:
a) Press Store 1 (= Cue 1)
b) Press Store 1 (= Cue 1) five times
c) Press Store 1 (= Cue 1) five times
view.
Cue 1 is stored on executor 4 along with a snap percent of 2.
Example 2
Let´s assume, you have stored cue 1 on the main executor and now you will add a snap percent of 2.
Press + Label (= Assign )
The snap percent of 2 is assigned at cue 1 on the main executor.
Double check the assigned snap percent in the
Related Links
Time Key
Cues View
© 2016 MA Lighting Technology Gm bH | Dachdeck erstr. 16 | D-97297 W aldbüttelbrunn | Germ any
Phone +49 5251 688865-27 | support (at) m a-dot2.com | www.m alighting.com
d o t 2 U s e r Ma n u a l
Exec 4 five times Time
Time (= SnapPercent)
Time (= SnapPercent)
1 (= Cue 1) five times
cues
(= SnapPercent) 2 Please
2 and press the respective executor button
2 and tap on executor 4 in the
Time (= SnapPercent) 2 Please
view.
Store and then five
.
.
executor bar
.
452