Snmp Read, Read Write Password And Trap Host Table Configuration; System Information Configuration - Proxim ORiNOCO AP-8000 User Manual

Using CLI to Manage the Access Point
Managing the Device Using CLI Commands
(config-mgmt-telnet)#password public
Device-Name# show management http
// RUNNING-CONFIGURATION //
// Telnet Configuration //
telnet {
password: ******
}

SNMP Read, Read Write Password and Trap Host Table Configuration

You can change the SNMP passwords using the following commands. To add an entry and enable the AP to send SNMP
trap messages to a Trap Host, specify the IP Address and Password for the Trap Host.
# configure
(config)# dev-management
(config-mgmt)# snmp
(config-mgmt-snmp)# read-password public
(config-mgmt-snmp)# read-write-password public
(config-mgmt-snmp)# trap-host-table
(config-mgmt-snmp-trap<tble>)# index 1 ipaddress 192.168.1.1
(config-mgmt-snmp-trap<tble>)# index 1 password public
Device-Name# show management snmp read-password
// RUNNING-CONFIGURATION //
// SNMP Configuration //
snmp {
read-password: ******
}
Device-Name# show management snmp read-write-password
// RUNNING-CONFIGURATION //
// SNMP Configuration //
snmp {
read-write-password: ******
}
Device-Name# show management snmp trap-host-table
// RUNNING-CONFIGURATION //
// SNMP Trap Host Table //
index 1 {
ip-address: 169.254.128.133
password: ******
}

System Information Configuration

Perform the following to configure the System Information entries.
# configure
(config)# dev-management
(config-mgmt)# system
(config-mgmt-sys)# system-information
(config-mgmt-sys-sysinfo)# ?
AP-8000 User Guide
134