Snmp Parameters; Snmp Table Host Table Parameters; Telnet Parameters - Proxim ORiNOCO AP-2500 User Manual

Using the Command Line Interface

SNMP Parameters

Name
SNMP
SNMP Management
Interface Bitmask
Read Password
Read/Write Password
SNMP Trap Host Table

SNMP Table Host Table Parameters

When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the "comment" argument.
Name
SNMP Trap Host Table
Table Index
IP Address
Password
Comment (optional)
Status (optional)

Telnet Parameters

Name
Telnet
Telnet Management
Interface Bitmask
Telnet Port
Telnet Login Inactivity
Time-out
Telnet Session Idle
Time-out
Type Values
Group N/A
Interface Bitmask 0 - no interfaces
(disable)
1 - Ethernet
4 - Wireless A
8- Wireless B
15 - all interfaces
DisplayString User Defined
public (default)
max 63 characters
DisplayString User Defined
public (default)
max 63 characters
N/A N/A
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
DisplayString User Defined
DisplayString User Defined
Integer enable
disable
delete
Type Values
Group N/A
Interface Bitmask 0 - no interfaces
(disable)
1 - Ethernet
4 - Wireless A
8- Wireless B
15 - all interfaces
Integer User Defined
23 (default)
Integer 1 – 60 seconds
30 sec (default)
Integer 1 - 900 seconds
900 sec (default)
Access CLI Parameter
R snmp
RW snmpifbitmask
W snmprpasswd
W snmprwpasswd
R snmptraphosttbl
Access CLI Parameter
R snmptraphosttbl
N/A index
RW ipaddr
W passwd
RW cmt
RW status
Access CLI Parameter
R telnet
RW telifbitmask
RW telport
RW tellogintout
RW telsessiontout
213