Alarms Parameters; Snmp Table Host Table Parameters; Syslog Parameters - Proxim AP-4000 User Manual

Using the Command Line Interface (CLI)
Parameter Tables
Protocol Name
Interface Bitmask
Status (optional)

Alarms Parameters

SNMP Table Host Table Parameters

When creating table entries, you may either specifying the argument name followed by argument value. CLI applies default values to the
omitted arguments. Due to the nature of the information, the only argument that can be omitted is the "comment" argument.
Name
SNMP Trap Host Table
Table Index
IP Address
Password
Comment (optional)
Status (optional)

Syslog Parameters

The following parameters configure the Syslog settings.
Name
Syslog
Syslog Status
Syslog Port
Syslog Lowest Priority
Logged
Heartbeat Status
Heartbeat Interval (seconds) Integer
NOTE
When Heartbeat is enabled, the AP periodically sends a message to the Syslog server to indicate that it is active. The frequency with
which the heartbeat message is sent depends upon the setting of the Heartbeat Interval.
DisplayString User Defined
(there are also 4
pre-defined protocols,
see Port Number
Integer32 0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless A
8 or 10 - Wireless B
12 = Wireless A & B
13 or 15 - all interfaces
(default is 15)
Integer enable (default for new
entries)
disable (default for
pre-defined entries)
delete
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
DisplayString User Defined (up to 64
characters)
DisplayString User Defined (up to 254
characters)
Integer enable (default)
disable
delete
Type Values
Group N/A
Integer enable
disable (default)
Octet String 514
Integer 1 – 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG
Integer enable (1)
disable (2) (default)
1 – 604800 seconds;
900 sec. (default)
RW protoname
above)
RW ifbitmask
RW status
Access CLI Parameter
R snmptraphosttbl
N/A index
RW ipaddr
W passwd
RW cmt
RW status
Access CLI
R syslog
RW syslogstatus
R syslogport
RW syslogpritolog
RW sysloghbstatus
RW sysloghbinterval
AP-4000 User Guide
173