Configuring Static Routes On The Pe Router; Configuring Ipv6 On The Interfaces - Juniper ACX1000 Configuration Manual

Configuring IPv6 on the Interfaces

Copyright © 2017, Juniper Networks, Inc.
interface interface-name;
}
}
You can include this statement at the following hierarchy levels:
[edit routing-instances routing-instance-name protocols]
[edit logical-systems logical-system-name routing-instances routing-instance-name
protocols]
NOTE: The [edit logical-systems]
Series routers.
For complete configuration guidelines for this statement, see the Junos OS Routing
Protocols Library.

Configuring Static Routes on the PE Router

To configure a static route to the CE router in the Layer 3 VPN routing instance, include
the statement:
routing-options
routing-options {
rib routing-table.inet6.0 {
static {
defaults {
static-options;
}
}
}
}
You can include this statement at the following hierarchy levels:
[edit routing-instances routing-instance-name]
[edit logical-systems logical-system-name routing-instances routing-instance-name]
NOTE: The
[edit logical-systems]
Series routers.
You need to configure IPv6 on the PE router interfaces to the CE routers and on the CE
router interfaces to the PE routers.
To configure the interface to handle IPv6 routes, include the
family inet6 {
address ipv6-address;
}
Chapter 26: Configuring Layer 3 VPNs
hierarchy level is not applicable in ACX
hierarchy level is not applicable in ACX
family inet6
statement:
847