Juniper ACX1000 Configuration Manual page 868

ACX Series Universal Access Router Configuration Guide
Meaning
810
Jabber frames
Fragment frames
VLAN tagged frames
Code violations
Filter statistics:
Input packet count
Input packet rejects
Input DA rejects
Input SA rejects
Output packet count
Output packet pad count
Output packet error count
CAM destination filters: 0, CAM source filters: 0
Autonegotiation information:
Negotiation status: Incomplete
Packet Forwarding Engine configuration:
Destination slot: 1
Logical interface ge-1/0/10.0 (Index 69) (SNMP ifIndex 59) (Generation 135)
Flags: Device-Down SNMP-Traps 0x0 Encapsulation: ENET2
Traffic statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
IPv6 transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Local statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
IPv6 transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Protocol inet, Generation: 144, Route table: 0
Flags: uRPF
Addresses, Flags: Is-Preferred Is-Primary
The show interfaces ge-1/0/10 extensive
command) displays in-depth information about the interface. The
detail
field near the bottom of the display reports the unicast RPF status. If unicast RPF has
not been enabled, the
uRPF
On EX3200 and EX4200 switches, unicast RPF is implicitly enabled on all switch
interfaces, including aggregated Ethernet interfaces (also referred to as link aggregation
groups or LAGs) and routed VLAN interfaces (RVIs) when you enable unicast RPF on a
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
command (and the
flag is not displayed.
0
0
0
0 bps
0 bps
0 pps
0 pps
show interfaces ge-1/0/10
output
Flags:
Copyright © 2017, Juniper Networks, Inc.