Allied Telesis x510-28GTX Command Reference Manual page 510

S C
WITCHING OMMANDS
-
CLEAR PORT SECURITY INTRUSION
Table 15-2: Example output from show port-security intrusion
To clear the history of port-security intrusion list on port1.0.1, use the following
command:
awplus#
To see the port-security status on port1.0.1, use the following command:
awplus#
Table 15-3: Example output from show port-security interface
NOTE
cleared from the database.
To see the intrusion list on port1.0.1, use the following command:
awplus#
Table 15-4: Example output from show port-security intrusion
C613-50170-01 Rev B

awplus#show port-security intrusion interface port1.0.1
Port Security Intrusion List
------------------------------------------------------------
Interface: port1.0.1
801f.0200.19da
clear port-security intrusion interface port1.0.1
show port-security interface port1.0.1

awplus#show port-security interface port1.0.1
Port Security configuration
------------------------------------------------------------
Security Enabled : YES
Port Status : ENABLED
Violation Mode : TRAP
Aging : OFF
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Lock Status : LOCKED
Security Violation Count : 0
Last Violation Source Address : None
: Note that the port status is still locked while the history of port violation is
show port-security intrusion interface port1.0.1

awplus#show port-security intrusion interface port1.0.1
Port Security Intrusion List
------------------------------------------------------------
Interface: port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
- 1 intrusion(s) detected
- no intrusions detected
510