Allied Telesis x510-28GTX Command Reference Manual page 484

Stackable gigabit edge switches x510 series
Table of Contents

Advertisement

P
M
R
ORT
IRRORING AND
EMOTE
MIRROR INTERFACE
Mode
Interface Configuration
Usage
Use this command to send traffic to another device connected to the mirror port
for monitoring.
For more information, see the
Guide.
A mirror port cannot be associated with a VLAN. If a switch port is configured to be
a mirror port, it is automatically removed from any VLAN it was associated with.
This command can only be applied to a single mirror (destination) port, not to a
range of ports, nor to a static or dynamic channel group. Do not apply multiple
interfaces with an interface command before issuing the mirror interface
command. One interface may have multiple mirror interfaces.
Access control lists can be used to mirror a subset of traffic from the mirrored port
by using the copy-to-mirror parameter in hardware ACL commands.
Example
To mirror traffic received and transmitted on port1.0.4 and port1.0.5 to destination
port1.0.3, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
direction both
To enable use with the
default-action
port, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To mirror TCP traffic to analyzer port1.0.1 if it is received or transmitted on port
1.0.2, use the sample configuration snippet below:
Related
access-list (numbered hardware ACL for IP packets)
Commands
access-list (numbered hardware ACL for MAC addresses)
default-action
C613-50170-01 Rev B
M
C
IRRORING
OMMANDS
configure terminal
interface port1.0.3
access-list (numbered hardware ACL for IP packets)
QoS commands to destination port1.0.3 without specifying a source
configure terminal
interface port1.0.3
awplus#show running-config
mls qos enable
access-list 3000 copy-to-mirror tcp any any
!
interface port1.0.1
mirror interface none
!
interface port1.0.2
access-group 3000
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Mirroring Feature Overview and Configuration
mirror interface port1.0.4,port1.0.5
mirror interface none
ACL and
484

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents