Allied Telesis x510-28GTX Command Reference Manual page 486

P M R
ORT IRRORING AND EMOTE
-
REMOTE MIRROR INTERFACE
This command can only be used to configure a single egress port on the source
device, not a range of egress ports. Do not use the interface command with
multiple interfaces before using this remote-mirror interface command. One
egress (destination) port on the source device can transmit mirrored frames from
up to four remote mirrored (source) ports.
The egress port on the source device can be associated with other VLANs in
addition to the remote mirror VLAN, so it can function as an uplink for traffic from
multiple VLANs. This command does not change the VLAN associations of the
mirrored ports.
Only one port on the device can be configured as either a mirror port for port
mirroring (mirror interface command) or as an egress port on the source device
for remote mirroring (remote-mirror interface command).
All mirrored ports on a single device must use the same remote mirror VLAN and
priority.
Access control lists can be used to mirror a subset of traffic from the mirrored port
by using the copy-to-mirror parameter in hardware ACL commands.
Example To configure the source device to send all the traffic that it receives on
remote-mirrored port 1.0.5 out egress port 1.0.1 tagged with remote mirroring
VLAN ID 2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
receive vlan 2
To stop port 1.0.1 remote-mirroring traffic received on mirrored port 1.0.5, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
direction receive
Related access-list (numbered hardware ACL for IP packets)
Commands
access-list (numbered hardware ACL for MAC addresses)
default-action
mirror interface
remote-mirror interface
show remote-mirror
switchport remote-mirror-egress
vlan mode remote-mirror-vlan
C613-50170-01 Rev B
M C
IRRORING OMMANDS
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
remote-mirror interface port1.0.5 direction
no remote-mirror interface port1.0.5
486