Remote-Mirror Interface - Allied Telesis x510-28GTX Command Reference Manual

P M R
ORT IRRORING AND EMOTE
-
REMOTE MIRROR INTERFACE

remote-mirror interface

Overview Use this command on the source device to specify the source port whose traffic is
to be remote-mirrored (monitored), and the remote mirroring VLAN ID these
mirrored frames will be tagged with when they egress from the source device. The
port for which Interface Configuration mode is entered is the port via which the
mirrored traffic egresses the source device towards the remote destination device.
Use the no variant of this command to disable remote mirroring of the specified
mirrored port by the egress (destination) port on the source device.
remote-mirror interface <port-list> direction
Syntax
{both|receive|transmit} vlan <2-4090> [priority <0-7>]
remote-mirror interface none vlan <2-4090> [priority <0-7>]
no remote-mirror interface <port-list> [direction
{receive|transmit}]
no remote-mirror interface none
Default No ports are set to be remote mirrored by default.
Mode Interface Configuration
Usage To prevent unwanted processing of mirrored traffic, we recommend configuring
remote monitoring on the receiving device before configuring it on the source
device.
C613-50170-01 Rev B
M C
IRRORING OMMANDS
Parameter
<port-list>
direction
both
receive
transmit
2-4090
priority
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The ports from which to mirror traffic. A port-list can be:
• a port (e.g. port1.0.2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.2 or port1.0.1-port1.0.24
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6
Specifies whether to mirror traffic that the source port
receives, transmits, or both.
Mirroring traffic both received and transmitted by the source
port.
Mirroring traffic received by the source port.
Mirroring traffic transmitted by the source port.
The VLAN ID of the remote mirroring VLAN that this mirrored
traffic is to be tagged with at the egress port on the source
device.
The 802.1p priority tag to apply to mirrored packets.
485