Show Interface Memory - Allied Telesis x510-28GTX Command Reference Manual

I C
NTERFACE OMMANDS

SHOW INTERFACE MEMORY

show interface memory
Overview This command displays the shared memory used by either all interfaces, or the
specified interface or interfaces. The output is useful for diagnostic purposes by
Allied Telesis authorized service personnel.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show interface memory
Syntax
show interface <port-list> memory
Mode User Exec and Privileged Exec
Example To display the shared memory used by all interfaces, use the command:
awplus#
To display the shared memory used by port1.0.1 and port1.0.5 to port1.0.6, use the
command:
awplus#
C613-50170-01 Rev B
Parameter Description
<port-list>
Display information about only the specified port or ports. The port
list can be:
• a switch port (e.g. port1.0.4), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen (e.g.
port1.0.1-1.0.4, or sa1-2, or po1-2)
• a comma-separated list of ports and port ranges (e.g.
port1.0.1,port1.0.4-1.0.6). Do not mix switch ports, static channel
groups, and dynamic (LACP) channel groups in the same list.
show interface memory
show interface port1.0.1,port1.0.5-1.0.6 memory
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
"Getting Started
Guide.
477