Routing Information Protocol (Rip); Novell Ipx - Allied Telesis AT-8800 SERIES User Manual

Layer 3
Figure 23: Example output from the SHOW IP RIP command.
Interface Circuit/DLCI
-------------------------------------------------------------------------------
vlan11 -
ppp0 -
-------------------------------------------------------------------------------
Software Release 2.6.1
C613-02039-00 REV A

Routing Information Protocol (RIP)

Routing protocols such as RIPv1 and RIPv2 can be enabled on a VLAN. For
example, to enable RIPv2 on the admin VLAN, use the command:
ADD IP RIP INTERFACE=vlan11 SEND=RIP2 RECEIVE=BOTH
To display information about RIP (Figure 23 on page 103), use the command:
SHOW IP RIP
IP Address
-
172.16.249.34

Novell IPX

The switch's implementation of the Novell IPX protocol uses the term circuit to
refer to a logical connection over an interface, similar to an X.25 permanent
virtual circuit (PVC) or a Frame Relay Data Link Connection (DLC). The term
interface is used to refer to the underlying physical interface, such as VLAN,
Ethernet, Point-to-Point (PPP) and Frame Relay.
To create IPX circuit 1 with the Novell network number 129 over the admin
VLAN, use the command:
ADD IPX CIRC=1 INTERFACE=vlan11 NETWORK=129 ENCAP=802.3
To display information about the circuits configured for IPX (Figure 24), use
the command:
SHOW IPX CIRCUIT
Send Receive Demand
RIP2 BOTH NO
RIP1 RIP2 YES
103
Auth Password
NO
PASS ********