disable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To stop the auto configuration function:
config autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the auto configuration timeout time to 100 seconds:
show autoconfig
Purpose
Syntax
Description
Parameters
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Use this to deactivate auto configuration from DHCP.
disable autoconfig
The disable autoconfig command is used to instruct the Switch not
to accept auto configuration instruction from the DHCP server. This
does not change the IP settings of the Switch. The ipif settings will
continue as DHCP client until changed with the config ipif command.
None.
Only Administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# disable autoconfig
Command: disable autoconfig
Success.
DGS-1210-28P/ME:5#
Use to configure the auto configuration timeout time from DHCP.
config autoconfig timeout <value 1-65535>
The config autoconfig command is used to the auto configuration
timeout time from DHCP.
timeout <value 1-65535> - Specifies the timeout time. And the value
is from 1 to 65535 seconds.
Only Administrator or operator-level users can issue this command.
DGS-1210-28P/ME:5# config autoconfig timeout 100
Command: config autoconfig timeout 100
Success.
DGS-1210-28P/ME:5#
Used to display the current autoconfig status of the Switch.
show autoconfig
The show autoconfig command is used to list the current status of
the auto configuration function.
None.
22