Table of Contents
Advertisement
4 Web-based Switch Configuration
Figure 4.91 - Configuration > Ethernet OAM > Ethernet OAM Event Configuration
From Port / To Port: Select a range of ports to be configured.
Link Event: Select the link event, Link Monitor or Critical Link Event.
Link Monitor: Select the link monitor. Avaliable options are Symbol Error, Frame Error, Frame Period
Error, and Frame Seconds Error.
Threshold (0-4294967295): Enter the number of error frame or symbol in the period is required to be equal
to or greater than in order for the event to be generated.
Window (1000-60000): Enter the period of error frame or symbol in milliseconds summary event.
Notify: Select the notification to be enabled or disabled.
Click the Apply button to accept the changes made.
Configuration > DDM > DDM Settings
The Digital Diagnostic Monitoring (DDM) functions allow the user to view the digital diagnostic monitoring
status of SFP modules inserting to the Switch and to configure related settings.
The DDM Settings page allows user to configure the action that will occur for specific ports when an
exceeding alarm threshold or warning threshold event is encountered.
Power Unit: Specifies the power unit for DDM. The options are mW (milliwatts) and dBm (decibel-milliwatts).
From Port / To Port: Specifies a port or range of ports to be configured.
State: Specifies to enable or disable the DDM settings state.
Shutdown: Specifies whether or not to shutdown the port, when the operating parameter exceeds the Alarm
or Warning threshold.
Click the Apply button to accept the changes made.
Figure 4.92 - Configuration > DDM > DDM Settings
7
7
2
2
D-Link DGS-2000 Series Ethernet Switch User Manual
Advertisement
Table of Contents
