Spanning Tree Protocol Commands; Config Stp Ports - D-Link DGS-1100-16/ME Reference Manual

SPANNING TREE PROTOCOL COMMANDS

The Spanning Tree Protocol commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

config stp ports

show stp ports
config stp trap
config stp version
enable stp
disable stp
show stp
Each command is listed in detail, as follows:
config stp ports
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<portlist> edge [true | false | auto]
{portlist <portlist>}
{ new_root [ enable | disable ] | topo_change [ enable | disable ] } (1)
[rstp | stp]
To set the edge state of each port.
config stp ports <portlist> edge [true | false | auto]
The config stp ports command sets the edge mode of each port.
The default value is true mode.
<portlist> – Specifies the port list to be configured.
edge [true | false | auto] – To set the STP mode of the ports. The
mode specified below:
• true – The port will connect to a network immediately, rather
than waiting for the spanning tree to converge.
• false – The port cannot enter forwarding state until the
spanning tree converge.
•
auto – The port will delay for a period and become edge port
if no bridge BPUD is received.
Only administrator-level users can issue this command.
130
25