Qos Commands; Config Bandwidth_Control - D-Link DGS-1100-06/ME Cli Reference Manual

The QoS commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config
bandwidth_control
show
bandwidth_control
config qos mode
show qos mode
config cos
ipv6_tc_mapping
show cos
ipv6_tc_mapping
delete cos
ipv6_tc_mapping
config
scheduling_mechanism
show
scheduling_mechanism
config dscp_mapping
show dscp_mapping
Each command is listed in detail, as follows:

config bandwidth_control

Purpose
Syntax
Description
Parameters
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[<portlist> | all] {rx_rate [no_limit | <value 64-1000000>] | tx_rate [no_limit |
<value 64-1000000>]}
{[<portlist> | all]}
[802.1p | dscp | portbased]
trafficclass <class_id 0-255> priority [high | highest | low | medium]
{trafficclasee <class_id 0-255>}
d{trafficclasee <class_id 0-255>}
[strict | wrr]
dscp_value <value 0-63> priority [high | highest | low | medium]
{dscp_value <value 0-63>}
To configure bandwidth control on the Switch.
config bandwidth control [<portlist> | all] {rx_rate [no_limit |
<value 64-1000000>] | tx_rate [no_limit | <value 64-1000000>]}
The config bandwidth_control command defines bandwidth
control.
portlist - A port or range of ports to be configured.
all - Specifies that the config bandwidth_control command applies
to all ports on the Switch.
rx_rate - Enables ingress rate limiting

no_limit – Indicates no limit is defined.

<value 64–1000000>] – Indicates a range between 64-
1000000 kbps.
tx_rate – Enables egress rate limiting.

QOS COMMANDS

107
16