Broadcast Storm Control Commands; Config Traffic Control - D-Link DGS-3100 SERIES Cli Manual

BROADCAST STORM CONTROL COMMANDS

The Broadcast Storm Control commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

config traffic control

show traffic control
Each command is listed in detail, as follows:
config traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure traffic control and enable broadcast storm control system wide:
Parameter
{[<portlist> | all] state [enable | disable] | storm_type [broadcast | multicast
_broadcast | dlf_ multicast _broadcast ] threshold <int 3500-1000000>}
{ports <portlist>}
To configure broadcast / multicast / unknown unicast traffic control.
config traffic control {[<portlist> | all] state [enable | disable] |
storm_type [broadcast | broadcast_multicast |
broadcast_multicast_dlf ] threshold <int 3500-1000000>}
The config traffic control command configures broadcast,
multicast and unknown unicast storm control.
<portlist> - A port or range of ports to be configured.
all − Specifies all ports on the Switch are to be configured.
storm_type – The type of broadcast storm for which to configure the
traffic control. The options are:
•
broadcast – Enables broadcast storm control only.
•
multicast_broadcast – Enables broadcast and multicast
storm control.
•
dlf_ multicast_broadcast - Enables broadcast, multicast and
unknown unicast storm control.
<int 3500-1000000> − The upper threshold at which the specified
traffic control is switched on. The value is the number of
broadcast/multicast/dlf packets, in Kbps, received by the Switch that
will trigger the storm traffic control measures. The value ranges in
size from 3500 to 1000000 Kbps.
Only administrator or operator-level users can issue this command.
DGS3100# config traffic control all state enable threshold 15000
storm_type multicast_broadcast
Success.
DGS3100#
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
11
86