Broadcast Storm Control Commands; Config Traffic Control - D-Link DGS-1100-06/ME Cli Reference Manual

BROADCAST STORM CONTROL COMMANDS

The Broadcast Storm Control commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

config traffic control

show traffic control
config traffic trap
Each command is listed in detail, as follows:
config traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[<portlist> | all] {[action [drop | shutdown] | countdown [0 | <minutes 5-30>] |
broadcast | multicast | unicast | threshold <value 0-1024000> | time_interval
<time_interval 5-30>]} [enable | disable]
{<portlist>}
[storm_cleared | storm_occured | both | none]
To configure broadcast / multicast / unknown unicast traffic control.
config traffic control [<portlist> | all] {[action [drop | shutdown]
| countdown [0 | <minutes 5-30>] | broadcast | multicast |
unicast | threshold <value 0-1024000> | time_interval
<time_interval 5-30>]} [enable | disable]
The config traffic control command configures broadcast,
multicast and unknown unicast storm control.
<portlist> - A port or range of ports to be configured.
all − Specifies all ports on the Switch are to be configured.
action [drop | shutdown] − Specifies the traffic control action to be
drop or shutdown. A traffic control trap is active only when the
control action is configured as "shutdown". If the control action is
"drop", there will no traps issue while storm event is detected.
countdown [0 | <minutes 5-30>] − Specifies the countdown time of
traffic control.
storm_type – The type of broadcast storm for which to configure the
traffic control. The options are:

broadcast – Enables broadcast storm control only.

multicast – Enables broadcast and multicast storm control.

unicast – Enables broadcast and unicast storm control.
threshold <value 0-1024000> − The upper threshold at which the
specified traffic control is switched on. The value is the number of
broadcast/multicast/dlf packets, in Kbps, received by the Switch that
will trigger the storm traffic control measures. The value ranges in
size from 0 to 1024000 Kbps. The default setting is 64 Kbit/sec.
<time_interval 5-30> − Specifies the time interval of traffic control.
[enable | disable] – Enables or disables the specified storm type.
Only administrator or operator-level users can issue this command.
104
15