Poe Commands; Config Poe System - D-Link DGS-1100-16/ME Reference Manual

The PoE commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

config poe system

config poe ports
show poe system
show poe ports
Each command is listed in detail, as follows:
config poe system
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the PoE system:
DGS-1100-24P/ME:admin#config poe system trap_state enable
Command : config poe system trap_state enable
Success.
DGS-1100-24P/ME:admin#
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
trap_state [enable | disable]
[all | portlist <portlist>]{ state [enable | disable] | time_range [ name <range_name 8>
| clear] | priority [critical | high | low] | power_limit [ auto | class_1| class_2 | class_3|
class_4| user_define <value m - n>]}(1)
{ port_list <portlist>}
To configure PoE system-wise function and port settings.
config poe system trap_state [enable | disable]
To configure PoE system-wise function.
trap_state[enable | disable] – To specify if the PoE trap was sent.
Only administrator-level users can issue this command.

POE COMMANDS

140
28