Poe Commands - D-Link xStack DGS-3400 Cli Manual

xStack
®
The xStack DGS–3426P supports Power over Ethernet (PoE) as defined by the IEEE 802.3af specification. Ports 1–24 supply 48
VDC power to PDs over Category 5 or Category 3 UTP Ethernet cables. The xStack
pinout Alternative A, whereby power is sent out over pins 1, 2, 3 and 6. The xStack
capable devices.
®
The xStack DGS–3426P includes the following PoE features:
•
The auto–discovery feature recognizes the connection of a PD (Powered Device) and automatically sends power to it.
•
The auto–disable feature will occur under two conditions: first, if the total power consumption exceeds the system
power limit; and second, if the per port power consumption exceeds the per port power limit.
•
The active circuit protection feature automatically disables the port if there is a short. Other ports will remain active.
PDs receive power according to the following classification:
Class
0
1
2
3
PSE provides power according to the following classification:
Class
0
1
2
3
The PoE commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config poe system
config poe ports
show poe ports
show poe system
Each command is listed in detail in the following sections.
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Max power used by PD
0.44 to 12.95W
0.44 to 3.84W
3.84 to 6.49W
6.49 to 12.95W
Max power provided by PSE
15.4W
4.0W
7.0W
15.4W
Parameters
{units [<unitlist> | all]} {power_limit <value 37–370> | power_disconnect_method
[deny_next_port | deny_low_priority_port] management_mode [power_limit | auto]} (1)
[all | <portlist>] {state [enable | disable] | priority [critical | high | low] | power_limit [class_0
| class_1 | class_2 | class_3 | user_define <value 1000–16800>]} (1)
{<portlist>}
{units <unitlist>}
®
®
DGS–3426P works with all D–Link 802.3af
306
P E C
O OMMANDS
DGS–3426P follows the standard PSE
39