Chapter 84 Power Over Ethernet (Poe) Commands; Config Poe Ports - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 84
(PoE) Commands
config poe ports [all | <portlist>] {state [enable | disable] | [time_range <range_name 32> |
clear_time_range] | priority [critical | high | low] | power_limit [class_0 | class_1 | class_2 |
class_3 | user_define <value 1000-35000>]}
config poe system {units [<unitlist> | all]} {power_limit <value 37-760> |
power_disconnect_method [deny_next_port | deny_low_priority_port] | legacy_pd [enable |
disable]}
show poe ports {<portlist>}
show poe system {units <unitlist>}
84-1

config poe ports

Description
This command is used to configure the PoE port settings.
Note: This command is only available to Switches in the DGS-3620 Series that support
Power over Ethernet.
Note: If the switch failed to supply power to the IEEE 802.3at PD (Powered Device), then
(1) check if the PD connected to the port supports the IEEE 802.3at standard or
(2) manually configure the corresponding port's power limit value to 30 Watts using
the config poe ports [all | <portlist>] power_limit user_define 30000
command.
Format
config poe ports [all | <portlist>] {state [enable | disable] | [time_range <range_name 32> |
clear_time_range] | priority [critical | high | low] | power_limit [class_0 | class_1 | class_2 |
class_3 | user_define <value 1000-35000>]}
Parameters
ports - Specifies the list of port used for this configuration.
all - Specifies that all the ports will be used for this configuration.
<portlist> - Enter the list of ports, used for this configuration, here.
state - (Optional) Specifies whether power will be supplied to the powered device connected to
this port or not.
enable - Specifies that PoE will be enabled of the specifies port(s).
disable - Specifies that PoE will be disabled of the specifies port(s).
time_range - (Optional) Specifies the time range that applies to the port of the PoE. If the time
range is configured, the power can only be supplied during the period specified by the time
range.
<range_name 32> - Enter the the time range name used here. This name can be up to 32
characters long.
clear_time_range - Specifies that the time range will be removed.
priority - (Optional) Port priority determines the priority the system attempts to supply the power
Power over Ethernet
977