Config Snmp Engineid; Create Snmp Group - D-Link DGS-1100-06/ME Cli Reference Manual

Command: show snmp community
SNMP Community Table
(Maximum Entries : 10)
Community Name
------------------------
public
private
Total Entries: 2
DGS-1100-06/ME:5#

config snmp engineID

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To give the SNMP agent on the Switch:
DGS-1100-06/ME:5#config snmp engineID 12345678900
Command: config snmp engineID 12345678900
Success!
DGS-1100-06/ME:5#

create snmp group

Purpose
Syntax
Description
Parameters
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
To configure a name for the SNMP engine on the Switch.
config snmp engineID <snmp_engineID 64>
The config snmp engineID command configures a name for the
SNMP engine on the Switch.
<snmp_engineID 64> − A string, of between 10 and 64
alphanumeric characters, to be used to identify the SNMP engine on
the Switch.
Only administrator or operate-level users can issue this command.
To create a new SNMP group, or a table that maps SNMP users to
SNMP views.
create snmp group <groupname 32> [v1 | v2c | v3
[noauth_nopriv | auth_nopriv | auth_priv]{notify_view
<view_name 32>}] {read_view <view_name 32> | write_view
<view_name 32>}
The create snmp group command creates a new SNMP group, or
a table that maps SNMP users to SNMP views.
<groupname 32> − A name of up to 30 alphanumeric characters that
identifies the SNMP group the new SNMP user is to be associated
with.
v1 – Specifies that SNMP version 1 is to be used. The Simple
Network Management Protocol (SNMP), version 1, is a network
User Name
------------
ReadOnly
ReadWrite
47