Status.operation.remote - Keithley 2657A Reference Manual

Model 2657A High Power System SourceMeter® Instrument Reference Manual

status.operation.remote.*

This attribute contains the operation status remote summary register set.
Type TSP-Link accessible
Attribute - -
.condition (R) Yes
.enable (RW) Yes
.event (R) Yes
.ntr (RW) Yes
.ptr (RW) Yes
Usage
operationRegister = status.operation.remote.condition
operationRegister = status.operation.remote.enable
operationRegister = status.operation.remote.event
operationRegister = status.operation.remote.ntr
operationRegister = status.operation.remote.ptr
status.operation.remote.enable = operationRegister
status.operation.remote.ntr = operationRegister
status.operation.remote.ptr = operationRegister
operationRegister
Details
These attributes are used to read or write to the operation status remote summary registers. Reading a status
register returns a value. The binary equivalent of the returned value indicates which register bits are set. The
least significant bit of the binary number is bit B0, and the most significant bit is bit B15.
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to
page E-1) and
the following table.
Bit
B0
B1
B2-B10
B11
B12-B15
2657A-901-01 Rev. B/December 2012
Affected by
- -
Not applicable
Status reset
Status reset
Status reset
Status reset
The status of the operation status remote summary register; a zero (0) indicates no
bits set (also send 0 to clear all bits); other values indicate various bit settings
Enable and transition registers
Value
Not used
status.operation.remote.COMMAND_AVAILABLE
status.operation.remote.CAV
Not used
status.operation.remote.PROMPTS_ENABLED
status.operation.remote.PRMPT
Not used
Where saved
- -
Not saved
Not saved
Not saved
Not saved
Not saved
(on page E-19). The individual bits of this register are defined in
Description
Not applicable.
Set bit indicates there is a command
available in the execution queue.
Bit B1 decimal value: 2
Binary value: 0000 0000 0000 0010
Not applicable.
Set bit indicates command prompts are
enabled.
Bit B11 decimal value: 2,048
Binary value: 0000 0100 0000 0000
Not applicable.
Section 7: TSP command reference
Default value
- -
Not applicable
0
0
0
2050 (All bits set)
Status register set contents (on
7-293