Bridge Multicast Forbidden Address - Dell PowerConnect 5324 Command Line Interface Reference Manual

bridge multicast forbidden address

The bridge multicast forbidden address Interface Configuration mode command forbids adding a
specific multicast address to specific ports. Use the no form of this command to return to default.
Syntax
bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} {add |
remove} {ethernet interface-list | port-channel port-channel-number-list}
no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address}
• add—Adds ports to the group.
• remove—Removes ports from the group.
• mac-multicast-address—MAC multicast address in the format of xx:xx:xx:xx:xx:xx.
• ip- multicast-address—IP multicast address is in the format xxx.xxx.xxx.xxx.
• interface-list—Separate non consecutive valid Ethernet ports with a comma and no
spaces; hyphen is used to designate a range of ports.
• port-channel-number-list—Separate non consecutive valid port-channels with a comma
and no spaces; a hyphen is used to designate a range of port-channels.
Default Configuration
No forbidden addresses are defined.
Command Modes
Interface Configuration (VLAN) mode
User Guidelines
• Before defining forbidden ports, the multicast group should be registered.
Examples
In this example the MAC address 01:00:5e:02:02:03 is forbidden on port g9 within VLAN 8.
Console (config)# interface vlan 8
Console (config-if)# bridge multicast address 01:00:5e:02:02:03
Console (config-if)# bridge multicast forbidden address
01:00:5e:02:02:03 add ethernet g9
80
Address Table Commands